4775LX 4×4 Loader 280 HP (209 KW)

4775LX

About This Product

ENGINE
Cummins QSC 8.3, Tier III, 280 HP (209 KW) @ 2,000 RPM / 260 HP (194 KW) @ 2,200 RPM, Peak torque of 870 FT-LB (1180 NM) @ 1,500 RPM, electronic fuel injection system
Severe dust, dry, dual stage air cleaner with service indicator
Pre-cleaner with automatic dust ejector
160-gallon fuel tank with lockable cap and 12-inch clean out door
Large tropical radiator, air to air, and hydraulic oil cooler
Fuel filter and water separator

TIRES
(2) 21.5 X 16.1, 12 ply, I-3 front tires
(2) 23.5 X 25, industrial rear tires mounted on three piece locking type industrial rims

HYDRAULIC SYSTEM
Open center for brakes, steering, conveyor, saw, table and cylinder functions
100% filtration
Front wheel power steering
70-gal pressurized hydraulic tank with 100% filtration via full flow spin-on canister type filters (70 gal capacity/60 gals oil) and 12 inch clean out door

ELECTRICAL
12-Volt DC engine system
12-Volt DC, roadway, and warning lights
(2) 12-VDC, 950 CCA, 180 RC Group 31XHE heavy duty maintenance free commercial batteries
160-Ampere alternator
Master Disconnect
Four adjustable headlights
Two adjustable back-up lights
Turn and warning/hazard lights

OPERATOR'S STATION
Open cab
Vinyl cushion mechanical suspension seat with position adjustment and armrest
Optional : Air conditioned cab with AM/FM stereo.
Air suspension seat

TRANSMISSION
Heavy duty variable displacement hydrostatic pump and fixed displacement heavy duty motor
Infinitely variable operating speeds in forward and reverse
Charge pump filtration
Hydraulically operated brakes on each rear wheels
Heavy duty final drives

STANDARD EQUIPMENT
Engine oil monitoring and warning
Engine coolant monitoring and warning
Voltage monitoring
Fuel gauge
Tachometer with hour meter
Hand throttle
Low hydraulic oil level light

DISCHARGE CONVEYOR
Hydraulically driven discharge conveyor
Rear wall of base loading conveyor behind knives/saw shaft is built of heavy plate to reduce damage and penetration when blade segments come off
Increased height to seal area above conveyor frame and top of loader frame to stop/reduce material blowing over the top of the conveyor and onto hydraulic tank and engine
Hinges and a latch to the base loading conveyor end cover on the right side/end of the loading conveyor to provide easy service access to the chain, sprockets, bearings, and slats

PICKUP CONVEYOR
Standard top and bottom chain conveyor
Bottom chain conveyor driven by two motors
Top chain conveyor driven by one motor
Front tire protection from loading conveyor outboard chain via plate with bent down ends to protect front tires from broken chain falling
Pickup conveyor lift and the pickup and hold down conveyor chain directional valves are directly linked to the operator control levers eliminating the control cables

SAW MECHANISM
Hydrostatic driven 9-blade saw (42″ diameter) on a high tensile steel tubular head shaft mounted on 2 heavy duty bearings which give any billet length required by the customer
Saw is driven by two heavy duty hydrostatic motors in closed loop with heavy duty variable displacement hydrostatic pump
Rear access door to service disc and blades

MISC OPTIONS
Fire extinguisher
2,000 hour filter package
2,000 hour spare parts package